Spring is the hardest season for sump pumps in Kenosha and Racine counties. Snowmelt, rain and frozen ground combine to send more water to the pit than at any other time of year. A few minutes of testing in late February or early March can prevent a flooded basement.
Before you start
Unplug the pump before reaching into the pit for anything. If the pump is hardwired, turn off its circuit. Keep a flashlight, a bucket and a towel handy. Never stand in water while handling electrical equipment.
Step 1: Look at the pit
Remove the lid and check:
- Is the pit clear of debris, gravel, silt and objects that could jam the float?
- Is the pump sitting level, ideally on a stable base?
- Is there water in the pit, and how high does it sit?
- Do any drain tile pipes enter the pit, and are they flowing?
Clean out sediment with a wet-dry vacuum if needed.
Step 2: Test the float and pump
Plug the pump back in. Slowly pour a bucket of water into the pit until the float rises and the pump starts. Watch for:
- The pump switching on at the expected water level.
- The pump clearing the pit quickly and shutting off.
- Unusual noise, rattling or vibration.
- The float moving easily without catching on the pit wall or the cord.
If the pump hums but does not move water, the impeller may be jammed or the motor may be failing.
Step 3: Check the check valve
The check valve sits on the discharge pipe above the pump and stops water from falling back into the pit. When the pump stops, a loud thud is normal for some valves, but water rushing back into the pit means the valve may be failing.
Step 4: Follow the discharge line
Go outside and follow the discharge pipe. Make sure it:
- Is not frozen, crushed or clogged with ice or debris.
- Ends far enough from the house that water does not return to the foundation.
- Does not discharge onto a neighbor's property or across a sidewalk where it can turn to ice.
- Is not connected to a sanitary sewer, which many communities prohibit.
Step 5: Test the backup
If you have a battery backup, unplug the main pump and let the backup run. Check the battery date and the charger lights. Many batteries need replacement every few years. If you have a water-powered backup, confirm the water supply valve is open, keeping in mind these generally need municipal water pressure.
Step 6: Test the alarm
Lift the alarm float or press its test button. If the alarm connects to Wi-Fi, confirm you get a notification.
Step 7: Look around the basement
Walk the perimeter. Look for damp spots at the floor-wall joint, new cracks, efflorescence and musty smells. Move stored items off the floor near walls.
Step 8: Outside before the thaw
- Clear snow away from the foundation and window wells.
- Clean gutters and make sure downspouts are attached and extended.
- Note low spots near the house to fill once the ground thaws.
When to call
Call to connect with a local specialist if your pump fails a test, runs constantly, short-cycles, is older than you remember, or if water appears in the basement anyway. Learn more in sump pumps and battery backups.
This guide is general information for homeowners, not engineering or legal advice. Conditions vary from home to home.
