At a glance
- Window wells collect rain, snowmelt and leaves
- A drain at the bottom of the well is essential
- Egress wells are large and need planned drainage
- Covers must open from inside on egress windows
A basement window is a hole in the foundation set at or below ground level. Every rainstorm and every spring thaw sends water toward it. In Kenosha and Racine, where snow piles up against houses through winter and melts in a rush, window wells are among the most frequent leak points in otherwise dry basements.
What a window well is supposed to do
The well is the excavated pocket outside the window, held back by a corrugated metal, plastic or masonry liner. Its bottom should be a few inches of gravel over a drain that connects to the footing drain or its own drain line. Water landing in the well should soak away before it ever reaches the bottom of the window frame.
Why wells fill up
- No drain at all. Many older wells have just soil or a thin gravel layer.
- Clogged drains. Silt, leaves and roots fill the drain pipe over time.
- Failed footing drain. If the well drain connects to old clay tile that has collapsed, water has nowhere to go.
- Roof water. An overflowing gutter or nearby downspout can pour straight into the well.
- Grading. Soil that slopes toward the well, or a liner rim set below surrounding grade, funnels runoff in.
- Liner gaps. Spaces between the liner and the foundation let soil and water wash through.
- Snow. Shoveled and drifted snow piles against windows, then melts directly into the well.
Signs of a problem
- Water standing in the well after rain or thaw.
- Water stains, rust or rot below the window inside.
- Mud or gravel on the basement floor under the window.
- Damp drywall or white residue under a window in a finished basement.
- Steel window frames that are rusting through.
Solutions
Clean and raise. Remove debris and organic buildup, add fresh gravel, and make sure the liner rim stands a few inches above grade.
Add a drain. A vertical pipe from the well bottom down to the footing drain, or a tie-in to an interior drain tile system, gives water a path out.
Install covers. Clear covers keep out rain, snow and leaves while letting light in. On egress windows, covers must be easy to open from inside so they do not block escape.
Replace the liner. A rusted or poorly sealed liner can be replaced and anchored to the foundation.
Replace the window. Rotted wood or rusted steel frames may need replacement with windows built for below-grade use, sealed and flashed properly.
Redirect roof water. Moving a downspout or adding gutter guards nearby is often the cheapest fix of all.
Egress windows
Egress windows provide an emergency exit from basement bedrooms and finished living spaces. Building codes set minimum opening and well sizes and require a way to climb out, such as a ladder or built-in steps. Large egress wells catch a lot more water than small window wells, so drainage should be part of the plan from the start. If you are adding egress as part of a basement remodel, ask about drainage connections, covers, and whether your city or village requires a permit.
Winter tips
- Clear snow from window wells, especially egress wells, after storms.
- Do not pile shoveled or plowed snow along the foundation near windows.
- Keep egress covers clear so they can open.
- Check for ice dams on the roof above windows, which can send meltwater down the wall.
Older homes and basement windows
Many older Kenosha and Racine homes have original steel-frame basement windows or glass block. Steel frames rust, glazing fails and surrounding masonry breaks down with age, so water may enter at the frame even if the well drains fine. Replacement options include vinyl windows sized for the masonry opening, glass block with a small vent, or enlarging the opening for egress where code allows.
Questions to ask
- Does the well have a drain, and where does it connect?
- Is the footing drain working?
- Should the rim be raised or the grade changed?
- Is a cover recommended, and will it meet egress requirements?
- Does the window itself need repair or replacement?
Cost factors
Well depth and size, liner condition, drain connections, cover type and window replacement drive the price. See what drives waterproofing cost.
Window wells on finished basements
When a basement is finished, a leaking window well can damage drywall, trim and carpet before anyone notices. Check wells after the first heavy storm each spring and after big thaws. A small investment in a cover and a working drain protects a much larger investment inside. If a finished basement has a musty smell near a window, look at the well first.
Neighbors and shared side yards
On narrow lots, a neighbor's downspout or sloping side yard can send water straight into your window wells. A conversation about where roof water goes, or a small swale between houses, can make a noticeable difference.
Reach a specialist
Call to reach an independent window well specialist serving Kenosha, Racine, Union Grove, Wind Lake, Bristol and the surrounding area.
Common questions
Why does my window well fill with water?
Common causes are a missing or clogged drain, roof runoff from a nearby gutter or downspout, poor grading and snow piled against the window.
Should window wells have covers?
Covers help keep out rain, snow and debris. Egress covers must open easily from inside.
Can a window well connect to drain tile?
Often yes. A drain at the bottom of the well can tie into the footing drain or an interior drain tile system.
Do egress windows need a permit?
Many municipalities require permits for egress window installation. Check with your city or village.
